HRC
Ground driven "V" wheel rakes
16-80 HP (12-60 KW)
Pull-type
Rotomec “V” rakes are available in working widths ranging from 5,2 to 7,8 meters and working speeds of up to 22 km/h. The wide working widths along with the low cost of ownership make the “V” rakes suited for larger hay foraging operations. All “V” rakes are equipped with two hydraulic cylinders for easy transport and storage of the rake. Hydraulic ball valves allow for single sided operation and provide additional security while rake is in transport. The optional center kicker wheel turns the hay in the center to improve bailing results.
"V" GROUND DRIVEN HAY RAKES
Model | HRC-08V | HRC-10V | HRC-12V |
|---|---|---|---|
HP | 30-80 | 30-80 | 30-80 |
Hitch | Pull-type | Pull-type | Pull-type |
Nr of wheels | 8 | 10 | 12 |
Wheel Ø (cm) | 140 | 140 | 140 |
Teeth per wheel | 40 | 40 | 40 |
Tooth Ø (mm) | 7 | 7 | 7 |
Working width (cm) | 640 | 700 | 780 |
Trasnport width (cm) | 244 | 244 | 244 |
Transport height (cm) | 270 | 305 | 368 |
Working speed km/h | 22,50 | 22,50 | 22,50 |
Weight Kg | 585 | 661 | 736 |
Raking (all models)
In the raking position, the rake wheels overlap front to back moving the crop to the center. Proper raking is obtained by positioning the bends, on both the
support arm and the arms with hubs, towards the back of the unit.
Turning (models HRC-08V, HRC-12V)
Hay rakes can be used to spread hay that has already been raked. This is
normally done to help wet hay dry faster. If the machine is assembled in the spreading position, all rake wheels will be aligned causing them to spread the hay across the width of the machine. Proper spreading is obtained by positioning the bends on both the support arm and the arms with hubs towards the tractor.
Spreading (models HRC-08V, HRC-12V)
In the turning position, each pair of rake wheels overlap front to back turning the forage crop and allowing it to dry faster. In the turning position, the finger wheels are set to work in pairs turning two windrows in each pass. Proper turning is obtained by positioning the bend on the support arm towards the tractor and bends on the arms with hubs towards the back of the unit
Ball valves on cylinders
All HRC wheel rakes are equipped with ball valves at the cylinders. Ball valves may be used to rake only on one side or for closing the hydraulic system for transport.
Springs
Springs allow for the wheel rakes to have sufficient ground pressure to rake the hay correctly and prevent excessive pressure from lifting up dirt onto the hay.
Tapered roller bearings
All wheel rakes are equipped tapered roller bearing mounted in cast steel, greasable hubs. The tapered roller bearings are more durable than the traditional bearings often used by the competition.
Upwards bent wheel elbows
RS2 rakes are equipped with upwards bent wheel elbows that allow for increased flow of raked hay through the wheel rake.
244 cm transport width
Thanks to it’s frames design, HRC rakes hydraulically fold to an 244 cm wide transport width.
Center kicker wheel
0099982 Center kicker wheel for all HRC model rakes (includes hydraulic cylinder)
Operator’s manual
Parts manual
